Allan & Heath Board Notes

The following is taken from HERE

Select Mix 1.
Hold down “Pre Fade” key.
The “Select Key” on each channel shows green if the mix is pre fade – press each select key and the green goes out – You now have that mix running post fade.
Set each channel fader to 0dB (or other level if required).
Repeat for other mixes.

Method 2 – See page 38

Select Mix 1.
Select the Master fader for Mix 1.
Press “Routing”.
Select “Mix Sends” from screen.
You now have a “Pre” or “Post” button on screen for all channels on each mix. Use this to select “Post”.
As before, set each channel fader to 0dB (or other level if required) for each mix.
Repeat for other mixes.